Home California locations San Diego Whole House Rewiring
Whole house rewiring in San Diego, CA
If your San Diego home has two-prong outlets, no ground, warm switch plates or an insurance company asking questions, the wiring is the issue. We rewire in planned phases so the house stays livable, and we cut access holes where they patch cleanly instead of wherever is fastest.
- 01Whole house rewiring
- 02Knob and tube replacement
- 03Aluminum wiring remediation
- 04Partial and phased rewires
- 05Ungrounded outlet correction
- 06Cloth and rubber insulation replacement
Whole House Rewiring jobs we take in San Diego
The work below covers the large majority of rewiring calls in San Diego and the wider San Diego County area.
Whole house rewiring
New copper branch circuits, grounded devices and a labeled panel throughout.
Knob and tube replacement
Removal of legacy open wiring and the splices hidden in the attic.
Aluminum wiring remediation
Pigtailing with listed connectors or full replacement of branch circuits.
Partial and phased rewires
Kitchen, bath and bedroom circuits done in stages on a budget.
Ungrounded outlet correction
Real grounds instead of a three-prong cover on a two-wire circuit.
Cloth and rubber insulation replacement
Brittle mid-century wiring pulled out and replaced.
Circuit separation
Splitting overloaded shared circuits into dedicated ones.
Drywall access and patching coordination
Minimal, planned openings with patch-ready edges.
Whole House Rewiring across San Diego
We cover every part of San Diego — Kearny Mesa, Pacific Beach, Point Loma and Mira Mesa included — along with the neighboring communities of Coronado and National City.
San Diego sits in San Diego County, and the electrical work here reflects that mix: older housing stock that needs grounding, capacity and device upgrades, alongside newer construction that simply needs more circuits than it was built with. Crews route through San Diego County daily, so travel time to a call in San Diego is short.
Whole House Rewiring in nearby cities
What affects rewiring pricing in San Diego
| Square footage and story count | Two-story homes without attic access above the first floor take longer. |
|---|---|
| Wall and ceiling material | Lath and plaster is slower and more fragile to open than drywall. |
| Existing wiring type | Knob and tube removal and aluminum remediation each carry their own scope. |
| Patching and finishing | You can keep patching separate or bundle it into the quote. |
Flat price, agreed before we start
You get one number for the whole rewiring job in San Diego before any work begins, including parts, permits where required, and cleanup.
How the visit works
You call, we answer
A dispatcher picks up 24 hours a day and gets the details — what is happening, where, and how urgent.
We diagnose before we price
The electrician tests and inspects, then explains what is actually wrong in plain terms.
You approve a flat price
One number for the whole job, agreed before any work starts. No hourly meter.
We do the work and clean up
Parts on the truck for most jobs, permits pulled where required, circuits labeled at the end.
Recent San Diego feedback
We rewired in stages so we could keep living here. They planned the access holes where the patcher could actually fix them, which I did not expect.
Ellen and Ray M.San Diego, CAAdded four outlets and GFCI protection in the garage and laundry. Small job, treated like a real one. Fair price, no upsell.
Lorraine T.San Diego, CARecessed lighting in the living room and hallway. They marked the layout on the floor first and asked before cutting. No flicker on the dimmers.
Curtis B.San Diego, CAWhole House Rewiring in San Diego — questions we get asked
How do I know if I have knob and tube wiring?
Look in the attic or basement for individual wires running through white ceramic knobs and tubes. Two-prong outlets throughout and a fuse box are strong supporting signs.
How much does it cost to rewire a house in San Diego?
Whole-home rewires in San Diego are priced by square footage, circuit count and access — a single-story home with an accessible attic and crawlspace costs far less than a two-story plaster home. We walk it, then give one firm number.
Is aluminum wiring dangerous?
Aluminum branch wiring from the 1960s and 70s is not inherently unusable, but its connections loosen and overheat over time. Remediation with listed connectors or replacement resolves it.
Do I have to move out during a rewire?
Usually not. We work in phases and keep power on to the areas you are using. Larger San Diego County projects sometimes have a day or two where it is easier to be elsewhere.
Will you patch the drywall?
We cut planned, patch-ready access and coordinate closely with your patcher or painter. Ask and we will quote the rewire with patching included.
Other electrical services in San Diego
- Emergency Electrician in San Diego
- Electrical Panel Upgrade in San Diego
- EV Charger Installation in San Diego
- Generator Installation in San Diego
- Lighting Installation in San Diego
- Electrical Repair & Troubleshooting in San Diego
- Outlet & Switch Installation in San Diego
- Commercial Electrician in San Diego
- Smart Home Wiring in San Diego
See all electrician services in San Diego
Related searches
whole house rewiring San Diego · house rewiring San Diego · home rewiring San Diego · electrical rewiring San Diego · knob and tube wiring replacement San Diego · aluminum wiring replacement San Diego · rewire house San Diego · whole house rewiring cost San Diego
Ready to book rewiring in San Diego?
Open 24 hours, 7 days a week. Flat pricing agreed before work starts.